Operating Combined Devices; All Off Function - Medion Remote Control Manual

Univ-FB_MD 81302_UK.fm Seite 20 Montag, 7. August 2006 11:08 11
For VCR codes you can use the button for programming,
if your video recorder has a Showview function.
If the device has both an EPG and a Showview function, the
EPG function is given priority.

Operating combined devices

Combined devices are for example a TV set with an
integrated video recorder, a TV set with a DVD player or a
DVD recorder with a video recorder. Several controlling
options are available to combined devices.
Combined devices with two device codes
Some combined devices (e.g. TV set with video recorder)
require two device codes - one for each device part. Program
the correct TV code on the TV mode key and the video
recorder code on the other mode key. The combined device
is then controlled like two separate devices.
Combined devices with one device code
Other combined devices only require one code. In this case,
you must first select the device part you would like to
operate.
Example: The device is a combined DVD recorder/video
recorder. The device code was stored on the DVD mode key.
Now activate the DVD part in the combined device by
holding down the DVD mode key for longer than one
second.
To activate the video recorder in the combined device,
first briefly press the S (Setup) key for the SHIFT function,
then the DVD mode key.
If your combined unit only requires one code but you would
like to operate it with two mode keys, then proceed as
follows:
Programme the device code to two mode keys.
Operate one of the unit parts with one of the two mode
keys.
Use the learn function (see "Learn function" on page 24 )
to transfer the desired functions of the other unit part to
the other mode key.

ALL OFF function

You can switch off all pre-programmed devices at the same
time. This is done as follows:
1. Press the POWER/ALL OFF key
succession and keep it pressed down after the second
time for approx. 3 seconds.
2. When you release the key,
OFF
appears and the devices
are switched off.
Some devices can be switched on and off with the POWER/
ALL OFF key
Devices switched off in such a way will, if
they were switched off, be switched back on when you
perform the ALL OFF function.
twice in rapid
ALL
20