Medion Remote Control Manual page 21

Univ-FB_MD 81302_UK.fm Seite 23 Montag, 7. August 2006 11:08 11
10. Press OK. You are prompted to
TIMER 1
make the first entry
KEY1
. Enter the first command.
In our example: Use the
number keys to select the
programme.
If no other input is needed, press OK or EXIT.
TIMER 1 KEY2
11. The display
appears. Enter the second
command.
In our example: Press the
Record key.
TIMER 1 KEY3
12. The display
appears after the second
command.
In our example, press the
Record key again.
SUCCESS
13. The confirmation
message appears along with
the bell symbol after the third
command.
14. Lay the universal remote control down so that it is
pointing towards the device and is not obstructed.
You can cancel programming at any time by pressing EXIT.
Delete command timer
If a command timer is set (the bell symbol appears in the
TIMER 1 CLEAR
display),
TIMER 1 SET
in the steps described above.
1. Perform steps 1 to 5 as
described above. The
CLEAR
display appears.
2. Press OK" The message
CONFIRM CLEAR
is displayed.
SUCCESS
3. Press OK" The
confirmation message appears.
appears in the display instead of
TIMER 1
23