Table of Contents
Advertisement
Light-Guided Diagnostics
The server board contains diagnostic LEDs to help you identify failed and failing components and to
help you identify the server from among several servers. Except for the ID LED, the status LED, and
the +5-volt standby LED, the LEDs turn on (amber) only if a failure occurs.
Callout
LED
A.
Bit 3 LED
B.
LSB LED
C.
Bit 2 LED
D.
MSB LED
E.
Status LED
ID LED
F.
G.
System fan 6 fault LED
MAXDATA Server PLATINUM 3200 I M6
I J K L M N O P
U
Figure 22. Diagnostic LEDs
Function
POST LEDs. The sequence of lit POST LEDs is used to identify
specific errors that might occur during the boot process. The LED
code will help technical support to identify possible problems.
The status LED indicates whether a system is operating
correctly, has experienced a minor fault, or a major system error.
This LED shows the same status as the front panel Status LED.
This LED can be turned on and off either by pressing a chassis
button or by using system management software. This LED is
useful when the system is grouped with several systems, such
as in a rack, and you need to easily find the system to perform
maintenance on it.
This LED indicates a fault has occurred with system fan 6. See
your server chassis documentation for instructions to replace
the fan.
A
C
B
D
E
F
G
H
Q
R
S
T
27
Advertisement
Table of Contents
