Contact With Liquid; Questions And Answers - Gigaset A110 Manual

Contact with liquid

If the handset should come into contact with liquid, on no account switch
the device on. Remove all batteries immediately.
Allow the liquid to drain out of the device, and then pat all parts of the device
dry. Keep the handset with the batteries removed in a warm, dry place for at
least 72 hours. You will normally then be able to use it again.
Range
The range is up to 300 m in the open. In buildings, ranges of up to 50 m can be
achieved. If you go outside the range, "*--*--* " appears in the display.
Recommended batteries
Sanyo Twicell 650; Sanyo Twicell 700; Panasonic 700mAh 'for DECT';
GP 550mAh; GP 700mAh; YDT AAA 600; YDT AAA Phone 700;
VARTA PhonePower AAA 700MAh.

Questions and Answers

Question
Nothing appears in the
display.
No radio link to base –
display shows
"*--*--*".
The caller's telephone
number is not displayed
although CLIP is set
(see page 7).
Service (Customer Care)
You can get assistance easily when you have technical questions or questions about how
to use your device by using our online support service on the Internet at:
www.my-siemens.com/customercare
or by referring to the section entitled Questions and answers in this manual.
!
Possible Cause
The batteries are flat.
Handset outside the
base station range.
Handset not registered.
Base not switched on.
Telephone number
identification is
blocked.
14
Possible solution
Charge or replace the batteries
(see page 5).
Reduce distance between handset
and base.
Register handset
(see page 10).
Check the mains connector on the
base (see page 4).
The caller must request
identification of his telephone
number from his network
provider.