Table of Contents
Advertisement
Manufacturer's advice
Care
Wipe the device with a damp cloth or an antistatic cloth. Do not use solvents or
microfibre cloths.
Never use a dry cloth; this can cause static.
In rare cases, contact with chemical substances can cause changes to the device's
exterior. Due to the wide variety of chemical products available on the market, it was
not possible to test all substances.
Impairments in high-gloss finishes can be carefully removed using display polishes
for mobile phones.
Contact with liquid
If the device comes into contact with liquid:
1 Unplug all cables from the device.
2 Remove the batteries and leave the battery compartment open.
3 Allow the liquid to drain from the device.
4 Pat all parts dry.
5 Place the device in a dry, warm place for at least 72 hours (not in a microwave,
oven etc.) with the battery compartment open and the keypad facing down (if
applicable).
6 Do not switch on the device again until it is completely dry.
When it has fully dried out, you will normally be able to use it again.
52
Advertisement
Table of Contents
