MATSONIC MS9158 Series User Manual page 34

Mainboard User's Manual
SDRAM CAS#
Latency
SDRAM Bank
Interleave
AGP Comp.
Driving
Manual AGP
Comp. Driving
AGP Mode
AGP Aperture
Size
Auto detect
DIMM/PCI
Clock
CLK GEN
Spread Spectrum
30
This item determines the operation of
SDRAM memory CAS (column address
strobe). It is recommended that you leave
this item at the default value. The 2T
setting requires faster memory that
specifically supports this mode.
Enable this item to increase SDRAM
memory speed. When enabled, separate
memory banks are set for odd and even
addresses and the next byte of memory
can be accessed while the current byte is
being refreshed.
Use this item to signal driving current on
AGP cards to auto or manual. Some
AGP cards need stronger than normal
driving current in order to operate. We
recommend that you set this item to the
default.
When AGP Driving is set to Manual, use
this item to set the AGP current driving
value.
This item provides the OnBoard VGA
mode with three options of 1,2, 4
multiplied frequency.
This item defines an AGP for the
graphics. Leave this item at the default
value 64MB.
When this item is enabled, BIOS will
disable the clock signal of free
DIMM/PCI slots.
Use this item to set the system bus
spread spectrum for the installed
processor.