MATSONIC MS9158 Series User Manual page 33

Enable this item if any IDE hard disks
S.M.A.R.T. for
support the S.M.A.R.T. (Self-
Hard Disks
Monitoring, Analysis and Reporting
Technology) feature.
This item determines if the Num Lock
BootUp Num-
key is active or inactive at system start-
Lock
up time.
If you have two diskette drives installed
Floppy Drive
and you enable this item, drive A
Swap
becomes drive B and drive B becomes
drive A.
If you enable this item, your system will
Floppy Drive
check all floppy disk drives at start up.
Seek
Disable this item unless you are using an
old 360KB drive.
If you have entered a password for the
Password Check
system, use this item to determine, if the
password is required to enter the Setup
Utility (Setup) or required both at start-
up and to enter the Setup Utility
(Always).
Enable this item if you are booting the
Boot to OS/2 >
OS/2 operating system and you have
64MB
more than 64MB of system memory
installed.
Leave these items enabled since all the
L2 Cache
processors that can be installed on this
board have internal L2 cache memory.
If you enable this item, a segment of the
System BIOS
system BIOS will be copied to main
Cacheable
memory for faster execution.
This item allows you to enable or disable
SDRAM Timing
the SDRAM timing defined by the Serial
By SPD
Presence Detect electrical.
This item determines frequency of
SDRAM
SDRAM memory.
Frequency
3: BIOS Setup Utility
29