Table of Contents
Advertisement
Changing the unit's settings
AV1 Output
Set according to the terminal of the connected TV.
Select "Video (with component)" or "S Video (with component)" for
component output (progressive output).
If this unit is connected with an HDMI cable, you cannot select
"RGB 1 (without component)" or "RGB 2 (without component)".
For Italy, Spain and Switzerland
When a decoder is connected, do not set to "RGB 1 (without
component)".
[Video (with component)]
Select when a TV is connected that can receive a composite
signal.
[S Video (with component)]
Select when a TV is connected that can receive an S Video
signal.
[RGB 1 (without component)]
Select when a TV is connected that can receive an RGB signal.
If you always would like to view the picture from the unit in RGB
signal, select this mode. The TV screen will automatically switch
to display the picture from the unit when the unit is turned on.
[RGB 2 (without component)]
Select when a TV is connected that can receive an RGB signal.
If you would like to switch to display the picture from the unit
only when playback or viewing menus, select this mode.
AV2 Settings
Set to match the connected equipment.
Press [OK] to show the following settings.
AV2 Input
Set to "RGB/Video" or "RGB" when receiving or recording RGB
output from external equipment.
[RGB/Video]
[RGB]
AV2 Connection
This setting is fi xed with "Ext" if you set "TV System" to "NTSC"
(➡ 75).
[Decoder]
When a decoder is connected to descramble the
scrambled signals (e.g., C+decoder).
[Ext]
When the VCR or a digital satellite receiver is
connected.
Ext Link
This setting cannot be made when the "TV System" is set to
"NTSC" (➡ 75).
[Ext Link 1]
When this unit is connected to a satellite receiver
with a 21-pin Scart cable and this unit receives a
control signal.
Start and stop timings of recording are controlled
by the control signal.
[Ext Link 2]
When external equipment with a timer function is
connected.
When it turns on, recording starts.
When it turns off, recording stops.
Active Antenna
(
For Germany
[On]
Select this when you will use indoor antenna.
[Off]
RQT9090
76
[Video]
[S Video]
(
)
For Italy, Spain and Switzerland
)
VHS
Tape Length
Set the length of the tape you are using so the unit can show the
correct remaining time.
[Auto (E-240)]
The unit automatically distinguishes E30, -60,
-90, -120, -180, and -240 tapes.
[E-195]
For E195 tape
[E-260]
For E260 tape
[E-300]
For E300 tape
Playback Colour System
[Automatic]
Differentiates between PAL and MESECAM.
[PAL]
If the PAL system is used.
[MESECAM]
If the MESECAM system is used.
SQPB
To play back video cassettes recorded in S-VHS format (SQPB;
S-VHS Quasi Playback)
[Automatic]
This unit automatically detects the format in
which the recording was made and selects the
same format for playback. However, picture
distortion may appear.
Therefore, set to [On] or [Off].
[On]
Use this setting when playing back a cassette
tape recorded in the S-VHS format.
[Off]
Use this setting when playing back a cassette
tape recorded in the VHS format only.
Hide quick links:
Advertisement
Table of Contents
