Pioneer XV-HTD640 Operating Instruction page 12

02 Connecting up
• These speaker terminals can be under
HAZARDOUS VOLTAGE. When you
connect or disconnect the speaker cables,
to prevent the risk of electric shock, do not
touch uninsulated parts before
disconnecting the power cord.
• Do not connect any of the supplied
speakers to any other amplifier. This may
result in malfunction or fire. This system is
designed for best performance when
connected to the supplied speakers. We do
not, therefore, recommend connecting and
using other speakers with this system.
1 Twist and pull off the protective shields
on each wire.
2 Connect to the speaker terminals on the
rear of the unit.
Match the colored wire with the color-coded
label (above the tabs), then insert the colored
wire into the red (+) tab and the other wire with
the black (–) tab.
3 Connect to the speaker terminals on the
rear of the speakers in the same way.
12
En
• Remove the supplied non-skid pads from
the paper, and stick four onto the base of
each satellite speaker (HTD-645DV only –
refer to the setup guide for more on this).
Actual speakers supplied may differ from
those shown.
4 Connect the WIRELESS (IN) jack on the
transmitter to the WIRELESS (OUT) jack on
the rear panel of the receiver, using the
supplied RCA stereo cord.
The wireless speaker system can be used for
multichannel sound with your main setup, or
as a second stereo speaker system.
5 Connect the supplied AC adapter to the
DC IN inlet on the rear panel of the unit,
then plug into a power outlet.
Transmitter
R L
IN
UND
L
AUDIO
COAXIAL IN
WIRELESS
OUT
LINE 2
R L
XV-HTD640
• Do not use any AC adapter but the one
provided with this system.
AC adaptor
To power outlet
ANTENNA
AM LOOP
ANTENNA
OUT IN IN
L L
FM
UNBAL
75
R R
LINE 1 TV