Other Settings You Can Make - Pioneer DVR-231-S Operating Instructions Manual

Getting started
6 Use the (cursor up/down) buttons to select
'Auto' or 'Manual' clock setting, then press ENTER.
Clock
Auto Date
Manual Time
Clock Set CH
• Auto clock setting
Some TV channels broadcast time signals together
with the program. This recorder can use these
signals to set the clock automatically.
Use the (cursor left/right) buttons to set
'Clock Set CH' to the channel preset number that
broadcasts a time signal, then move the cursor
down to 'Start' and press ENTER.
Auto
Auto Date
Manual Time
Clock Set CH
The recorder takes a short while to set the time. After
you see that the time has been set, select Next to
proceed.
Auto
Auto Date
Manual Time
Clock Set CH
If the time could not be set automatically, press
RETURN to go back to the previous screen and select
Manual.
• Manual clock setting
If no stations in your area are broadcasting time
signals, you can set the clock manually.
Use the (cursor left/right) buttons to set
your time zone.
Manual
Auto Date
Manual Time
Time Zone
D.S.T.
- - / - - / - - - -
- - : - - AM
0 0 2
Start
01 / 01 / 2005 SAT
12 : 00 AM
0 0 2
Start
Next
01 / 01 / 2005 SAT
12 : 00 AM
USA
Alaska
Off
Press (cursor down) then use the
left/right) buttons to set D.S.T. to On or Off, then
press ENTER.
Select On if you are currently using daylight saving
time.
Set the current date and time.
Manual
Auto Date
Manual Time
Time Zone
D.S.T.
• Use the (cursor up/down) buttons to change
the value in the highlighted field.
• Use the (cursor left/right) buttons to move
from one field to another.
• Press ENTER to finish setting the time.
7 That's it! Press ENTER to finish setting up.
Setup Navigator
Setup is complete!
Enjoy using your DVD recorder!
Finish Setup

Other settings you can make

After setting up using the Setup Navigator, you should be
ready to start enjoying your DVD recorder. It's possible,
however, that you may want to make a couple of
additional settings, depending on how the recorder is set
up for TV broadcasts.
• Manual channel setting – This setting lets you skip
channels where there is no station, as well as
manually tune to stations. See Manual CH Setup on
page 47.
• VCR Plus+ channel setting – This setting lets you
assign guide channels to ensure that the VCR Plus+
programming system works correctly. See Guide CH
Setup on page 47.
(cursor
01 / 01 / 2005 SAT
12 : 00 AM
USA
Alaska
Off
04
21
En