Error Messages - Panasonic DMR-E100H Operating Instructions Manual

∫ Helpful Hints
PDC
PDC (Programme Delivery Control)
Programme Delivery Control adjusts the start and stop time of a
timer recording automatically to ensure the recording starts and
finishes in line with the programme broadcast. This is useful when
a programme over-runs the published times.
The station must be transmitting PDC and the exact time must be
set for PDC to work.
Title/Chapter (DVD-Video)
DVD-Video are divided into large sections (titles) and smaller
sections (chapters). The numbers allocated to these sections are
called title numbers and chapter numbers.
Example
(1)
(3) (4)
(1) Title 1
(2) Title 2
(3) Chapter 1
(4) Chapter 2
(5) Chapter 3

Error messages

On the unit's display
Indications Unit status
The disc is dirty or badly scratched. ≥Follow the instructions in "Maintenance and Handling" to clean the disc if it is
NO READ
It can not be read for the disc which
doesn't cope with it.
The DVD-RAM/PD lens cleaner
has finished cleaning.
UNSUPPORT You have inserted a disc the unit
cannot play or record on.
U14 The unit is hot.
U99 The unit fails to operate properly.
REMOTE The remote control and main unit
DVD are using different codes.
SELF A power failure occurred or the AC
CHECK mains plug was disconnected while
the power was ON. However, self
check is also activated when this
unit is normally turned on.
HDD SLEEP The HDD is paused to extend its
lifetime.
(2)
(5) (4)
(3)
Solutions
dirty.
≥The disc is not available if it is scratched and this display doesn't disappear.
≥Exchange a disc.
≥Take the cleaner out of the unit.
≥Insert a disc the unit can play or record on.
≥The unit switches to standby automatically for safety reasons and cannot be
operated. Wait for about 30 minutes for the service number to disappear.
≥Select a position with good ventilation when installing the unit.
≥Do not block the cooling fan on the rear of the unit.
≥Press [Í/I] to switch the unit to standby. Now press [Í/I] again to turn the
unit on.
≥Change the code on the remote control or main unit.
≥The unit is carrying out its recovery process. Wait until the message
disappears.
≥Press [HDD] to start.
68
The unit detects whether a station is transmitting PDC only during
the tuning process.
If PDC is introduced or discontinued by a station you will need to
re-tune the unit before it becomes aware of this.
PDC transmissions are not currently nation-wide so please check
with your local broadcaster for more information.
The beginnings of recordings may not be recorded correctly in
some cases.
Track
This is the smallest division on CD, and Video CD.
Example
(1) (2)
(1) Track 1
(2) Track 2
(3) Track 3
(4) Track 4
(5) Track 5
(3) (4) (5)
Page
66
–
–
–
9
–
–
–
–
62
–
–