Attaching And Removing The Vacuum Bag - Ryobi RESV1300 Operator's Manual

ATTACHING AND REMOVING THE VACUUM
BAG
Attaching
NOTE: The Vacuum Bag comes un assembled on this
unit. Installation is required to provide safe and
easy use for the operator.
1. Attach the vacuum bag to the vacuum bag hook on
the blower/vacuum tube (Fig. 3).
2. Slide the vacuum bag tube over the debris exhaust
tube on the housing. Push the tube until the latching
tabs on both sides click into place, securing the bag
on the unit (Fig. 4).
Latching tabs
8
ASSEMBLY INSTRUCTIONS
Vacuum Bag Hook
Fig. 3
Debris Exhaust Tube
Vacuum Bag Tube
Vacuum Bag
Zipper
Fig. 4
Removing
NOTE: It is necessary to remove the Vacuum Bag to
empty and clean the bag.
1. Press the latching tabs on both sides of the vacuum
bag tube and pull the vacuum bag from the unit
(Fig. 5).
2. Detach the vacuum bag from the vacuum bag hook
(Fig. 3).
3. Replace Bag before using unit.
Latching tabs
Fig. 5