Philips voice dect User Manual page 37

Problems when faxing or printing
Faxes are of poor quality.
Your fax or your recipient's fax machine produces
black lines when printing.
Copy is blank.
Problems with the connection
Your fax machine rings once, then there is a mo-
ment of silence and another ring signal after that.
NO CONNECTION
or REDIAL FAILED
NO LOOP CURRENT
When you lift the cordless handset you do not
hear the dial tone.
BUSY
or
fax transmissions are constantly interrupted.
You cannot receive any faxes.
On lifting the cordless handset you hear a tone or
silence.
EXTERNAL PHONE
The red lamp v fl ashes.
Problems with the cordless handset
There is no dial tone on the cordless handset.
You cannot hear a dial tone even though the cord-
less handset has been recharging on the base sta-
tion for more than 12 hours.
Change the resolution setting to F or f.
Check the document or set a higher contrast with
function 47 (see chapter Fax & Copy / Con-
trast).
Test the fax machine by making a copy. If your
copy is faultless the correspondent's fax machine
might be defective.
Call service if necessary.
Clean the scanner with a cloth (see Care).
Test the fax machine by making a copy. If your
copy is faultless the correspondent's fax machine
might be defective.
Call service if necessary.
Load the document with the printed side up.
Call service if necessary.
This is entirely normal. After the fi rst ring signal
the fax machine takes over the call. When the fax
machine has recognised that the incoming call is
a telephone correspondence, the fax machine will
continue to ring.
Try later or draw your fax partner's attention to a
possible installation fault.
Check the installation of your fax machine.
Connect your telephone cable to the socket on
your fax machine identifi ed with LINE.
Try to send the fax manually: Press z and dial
the fax number. If the recipient is using an auto-
matic answering device, wait until you hear a tone
after the pre-recorded message. Press START.
Set the number of ringing signals for the answer-
ing machine or the total number of ringing signals
with function 31 or 32 to lower than fi ve.
You are receiving a fax. At the fax machine: Press
START. At an additional telephone: press *
and 5. Replace the handset.
This is not a fault. You are now using an addi-
tional telephone.
Place the cordless handset on the base station and
wait at least 12 hours until the batteries are fully
recharged.
Get closer to the fax machine so you are within
the maximum range.
Please contact your dealer for new batteries of the
type AAA.
37