Get Started; Connect The Base Station And Charger - Philips XL590 User Manual

3 Get started

Caution
•
Make sure that you have read the safety instructions in
the 'Important safety instruction' section before you
connect and install your handset.
Connect the base station and
charger
Warning
•
Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back or underside of the phone.
•
Use only the supplied power adapter to charge the
batteries.
Note
•
If you subscribe to the digital subscriber line (DSL)
high speed internet service through your telephone
line, make sure you install a DSL filter between the
telephone line cord and the power socket.. The filter
prevents noise and caller ID problems caused by DSL
interference. For further information on DSL filters,
contact your DSL service provider.
•
The type plate is located on the bottom of the base
station.
EN
8
1
Connect each end of the power adapter to:
• the DC input jack at the back of the
base station;
• the power socket on the wall.
2
Connect each end of the line cord to:
• the telephone socket at the back of the
base station;
• the telephone socket on the wall.
3
Connect each end of the power adapter to
(for multi handset versions only):
• the DC input jack at the back of the
extra handset charger.
• the power socket on the wall.