Install The Car Audio System - Philips CE139DR User Manual

q
• For .wma and .mp3 tracks on a storage
device, press to select the next folder.
• In DAB mode, press and hold to access
the list of radio stations.
• In a mode other than DAB mode,
press and hold to activate the selection
of listening zones.
• Press to select a tuner band.
/
r
• Tune to a radio station.
• Press to skip to the previous/next
track.
• Press and hold to rewind a track or
search fast forward.
s
• Press to enable or disable the MAX
Sound feature.
• Press and hold to enable or disable
the DBB (dynamic bass boost) sound
effect.
t BAND
• Press repeatedly to select a tuner band.
u
• Insert an SD/SDHC card.
v RESET
• Press to reset the system.
EN
6
3 Install the car
audio system
Caution
•
Use the controls only as stated in this user manual.
Always follow the instructions in this chapter in
sequence.
These instructions are for a typical installation.
However, if your car has different requirements,
make the adjustment accordingly. If you have
any question regarding installation kits, consult
your local retailer.
Note
•
This system is designed for negative ground (earth) 12V
DC operation only.
•
Always install this system in the car dashboard. Other
locations can be dangerous as the rear of the system
heats up during use.
•
To avoid short-circuit: before you connect, make sure
that the ignition is off.
•
Make sure that you connect the yellow and red power
supply leads after all other leads are connected.
•
Make sure that all loose leads are insulated with
electrical tape.
•
Make sure that the leads do not get caught under
screws iron parts that will move (e.g. seat rail).
•
Make sure that all ground (earth) leads are run to a
common ground (earth) point.
•
Use only the supplied mounting hardware for a safe
and secure installation.
•
Improper fuses can cause damage or fire. When you
need to change the fuse, consult a professional.
•
When you connect other devices to this system, make
sure that the rating of the car circuit is higher than the
total fuse value of all the connected devices.
•
Never connect speaker wires to the metal body or
chassis of the car.
•
Never connect speaker wires with stripes to one
another.