•
To tune to a programmed radio
station, press its corresponding
numeric button
,
,
,
, , or
.
Program stations manually
1
Tune to the target detected station (see
‘Tune to a detected station’ on page 15).
2
Press
/
repeatedly to select a band.
3
Press and hold a numeric button
,
,
,
, , or
to assign
a sequence number to the station.
» [SAVED] is displayed.
» The station is programmed with the
sequence number.
4
Repeat the steps above to program more
stations.
•
To tune to a programmed radio
station, press its corresponding
numeric button
,
,
,
, , or
.
Display DAB information
The name of current DAB station is displayed.
You can also view the other information.
To cycle through available information, press
DISP repeatedly.
•
Dynamic label segment (DLS)
•
Signal strength
•
Program type (PTY)
•
Ensemble name
•
Frequency
•
Signal error rate
•
Bitrate codec
•
Time
•
Date
EN
Set up for weak reception
When the current reception gets poor, the
product can automatically switch the source or
mute the speakers according to your setup.
1
Press and hold
to access the system
menu.
» [DAB SCAN] is displayed.
2
Press
/
repeatedly until
[DAB WEAK] scrolls.
3
Rotate
to select an option, and then
press
to confirm.
[WEAK MUTE]: Mute the speakers
•
[WEAK TO FM]: Switch the source
•
to an FM radio station with strong
reception that broadcasts the same
program
Use the DRC (Dynamic
Range Control)
DRC adds or removes a degree of
compensation for the differences in the dynamic
range between radio stations.
1
Press and hold
to access the system menu.
» [DAB SCAN] is displayed.
2
Press
/
repeatedly until one of the
following options is displayed.
[DRC OFF]: No compensation applied.
•
[DRC LOW]: Medium compensation
•
applied.
[DRC HIGH]: Maximum
•
compensation applied.
3
Rotate
to select an option.
Disable the DAB reception
1
Press and hold
to access the system
menu.
» [DAB SCAN] is displayed.
2
Press
/
repeatedly until
[ANTENNA OFF] or [ANTENNA 12V]
is displayed.
Page 16