Connect Wires - Philips CE139DR User Manual

Connect wires

Note
•
Make sure that all loose leads are insulated with
electrical tape.
•
Consult a professional to connect wires as instructed
below.
1
Check the car's wiring carefully and
connect them to the the supplied ISO
male connectors.
ISO male
connectors
1 Green strip, black-
edged green strip
2 White strip, black-
edged white strip
3 Gray strip, black-
edged gray strip
4 Purple strip, black-
edged purple strip
e Red strip
f Blue strip
g White-edged blue
strip
h Black strip
i Yellow strip
Connect to
Rear left speaker
Front left speaker
Front right speaker
Rear right speaker
Ignition key +12V
DC when ON/ACC
Motor/electric
antenna relay control
lead
Amplifier relay
control lead
Ground
To the +12V car
battery which is
energized at all times
2
Connect other wires if necessary.
c d e f
Sockets or
connectors on rear
panel
1 USB connector
2 Purple strip
3 FM/MW radio
antenna socket
4 DAB radio receiver
socket
REAR R
5
REAR L
6
7 For ISO male
connectors
Tip
•
The pin arrangement for the ISO connectors depends
on the type of your vehicle. To avoid damage to the
unit, connect properly.
a
b
g
External sockets or
connectors
A USB storage device
or iPod/iPhone
OE remote control
module
FM/MW radio
antenna
DAB radio receiver
Rear right speaker
Rear left speaker
ISO male connectors
EN
7