Positioning The Logs - Quadra-Fire HUDBAY-FS Owner's Manual

Bend retaining tabs on left and right sides inward
Figure 8.10
to hold brick in place.
Install the rear brick. Slide it in at an angle and place
Figure 8.11
over the rear brick retainer. Hand bend retaining tabs up to
hold brick in place. Push baffle towards back of firebox.
NOTE: For the Hudson Bay Free Standing the
Figure 8.12
upper rear brick retainer is used.
Reinstall the pilot shield with the screws removed in Figure
8.6. The pilot shield must be in place before operation of
appliance.
Page 30
2 retaining tabs
on right and left
sides
Rear brick retainers
Quadra-Fire • Hudson Bay • 7003-121 Rev. Q • 8/13
F. Positioning the Logs
While still breakable, the logs do not become fragile until
after the appliance is burned and they have cured. After
curing, any handling must be done with care as breakage
can easily occur.
PLEASE NOTE: Logs have been designed to work
specifically with the burner of this appliance. Exact
placement will ensure proper operation of your gas
appliance and reduce sooting.
#3
#6
Log Set.
Figure 8.13
#3
#6
#1
Logs shown installed in firebox. Logs #1 and #2 are
Figure 8.14
part of the burner pan and are numbered for reference only.
Install the left rear log (#3) over the locater pins
Figure 8.15
in the burner pan.
#4
#5
#5
#4
#2