Section 8: Appliance Setup; Remove Shipping Materials; Accessories; Door Crown Installation - Quadra-Fire HUDBAY-FS Owner's Manual

8
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
B. Accessories
Install approved accessories per instructions included with
accessories. Refer to Section 12 for appropriate accesso-
ries.
WARNING
Shock or fire risk.
Use ONLY optional accessories approved for
this appliance.
• U s i n g n o n - l i s t e d a c c e s s o r i e s v o i d s
warranty.
• Using non-listed accessories may result in a
safety hazard.
• Only Hearth & Home Technologies approved
accessories may be used safely.
C. Door Crown Installation
Open lower access panel. Pull out and unhook
Figure 8.1
the two spring latches on the bottom of the appliance that
secure the door.
Rotate the door forward approximately 1-1/2 in. (38mm).
Holding the ashlip, lift the door up off of the stationary latches
and away from the appliance.
Page 28
Stationary latches
Spring latches
Quadra-Fire • Hudson Bay • 7003-121 Rev. Q • 8/13
Uninstall the existing crown by removing the four
Figure 8.2
screws on the back side of the door. Retain the screws.
Use a flat-head screwdriver to pry the black crown
Figure 8.3
free on the right side. Remove the crown and discard.
Carefully align the left side of the crown into place,
Figure 8.4
and wrap it across the face of door, finally snapping it into
place on the right hand side. Reinsert and tighten the screws
previously removed.
Use a soft cloth and a window cleaning solution to clean
all fingerprint oils from the gold or nickel surface of crown
PRIOR to lighting the appliance.