Grille Installation; Brick Installation - Quadra-Fire HUDBAY-FS Owner's Manual

D. Grille Installation
Following instructions stated above, remove the
Figure 8.5
door of appliance.
Remove the four screws (two at each end) holding the grille
in place. Lift up to remove.
Install the new grille by reversing the removal instructions.
NOTE: Clean glass and gold or nickel plating with glass
cleaner and a soft cloth, wiping off all fingerprints prior to first
fire to prevent permanent staining.
E. Brick Set Installation
Pilot Bracket
The pilot shield has to be removed to install or
Figure 8.6
remove the brick refractory. Removal of the bracket requires
removing two screws.
Pilot
Shield
Quadra-Fire • Hudson Bay • 7003-121 Rev. Q • 8/13
To install the baffle, slide it in at an angle and rotate
Figure 8.7
upward parallel with the firebox. Place baffle up against
the heat exchangers in top of firebox. Holding against heat
exchangers, slide baffle towards front of appliance.
Keeping the baffle elevated with your free hand,
Figure 8.8
put the right side brick into position. Rest the baffle on the
right side brick.
Still holding the baffle in place, install the left brick
Figure 8.9
into position.
Page 29