Setting The Id Number Of The Remote Control - Mitsubishi Electric XD8100U User Manual

Using the remote control (continued)
Setting the ID number of the remote
control
You can control multiple projectors collectively or
individually using one remote control by setting the ID
number (CONTROLLER ID) of the remote control.
To control multiple projectors using the remote
control, you need to select the projector's ID number
(PROJECTOR ID) with the remote control in advance.
ID numbers should be two-digit numbers "01" to "63"
or "ALL." Other numbers cannot be used.
• For setting the ID number of the projector, see page
60.
ID button
Setting by the remote control alone
1. While holding down the ID button on the remote
control, press the number buttons (0 to 9) to set a
two-digit ID number.
Or, while holding down the ID button on the remote
control, press the ALL button.
• You cannot set the ID number by pressing the
number buttons (0 to 9) or the ALL button unless
pressing them while holding down the ID button
on the remote control.
• You can set the CONTROLLER ID using the
remote control alone. When you set the ID with
the remote control directed to the projector, you
can see the setting status on the screen.
Setting by using the projector
1. Carry out the procedure described in "Setting by
the remote control alone" with the remote control
directed to the projector.
• The ID setting dialog box is displayed on the
upper right area of the screen.
PROJECTOR ID
CONTROLLER ID
(01 - 63/ALL)
Number (0 to 9)
buttons
ALL button
XX
YY  ZZ
EN-10
XX: Shows the ID number of the projector.
(When the PROJECTOR ID is "ALL," "ALL"
is displayed.)
YY: Shows the current CONTROLLER ID. (When
the CONTROLLER ID is "ALL," "ALL" is
displayed.)
ZZ: Shows the CONTROLLER ID to be changed.
(When the CONTROLLER ID is "ALL," "ALL"
is displayed.)
• Before a CONTROLLER ID is entered, ** is
displayed. When you press a number button (0
to 9), the left digit of the ID number is entered
fi rst.
When the CONTROLLER ID setting has succeeded:
PROJECTOR ID
CONTROLLER ID
(01 - 63/ALL)
"COMPLETE" is displayed under the
CONTROLLER ID number you entered.
• The ID setting dialog box automatically
disappears after it is displayed for about 5
seconds.
• By pressing any button other than the ID button,
number buttons (0 to 9), and ALL button while
the ID setting dialog box is being displayed, you
can cancel the dialog box.
When the CONTROLLER ID setting has failed:
PROJECTOR ID
CONTROLLER ID
(01 - 63/ALL)
"ERROR" is displayed under the CONTROLLER ID
number you entered.
• The ID setting dialog box automatically
disappears after it is displayed for about 5
seconds.
• By pressing any button other than the ID button,
number buttons (0 to 9), and ALL button while
the ID setting dialog box is being displayed, you
can cancel the dialog box.
Important:
• ID numbers should be two-digit numbers "01" to
"63." The other numbers are invalid.
• When the PROJECTOR ID number is any of
"01" to "63," you can control the projector
by matching the CONTROLLER ID with the
PROJECTOR ID number or setting it to "ALL."
• When the PROJECTOR ID number is "ALL,"
you can control the projector using the remote
control regardless of the CONTROLLER ID
number.
• When the PROJECTOR ID number is uncertain,
you can control the projector regardless of the
ID number by setting the CONTROLLER ID to
"ALL."
XX
YY  ZZ
COMPLETE
XX
YY  ZZ
ERROR