Smart Function Key (Top Key); One Touch Eco Mode - Panasonic KX-TG6711FX Operating Instructions Manual

Getting Started
Dialling mode
If you cannot make calls, change this setting
according to your telephone line service. The
default setting is "Tone".
"Tone": For tone dial service.
"Pulse": For rotary/pulse dial service.
1
#120
2
MbN: Select the desired setting.
3
a M N
Smart function key (Top
Key)
The smart function key (Top Key) is located
on the top of the handset and informs you with
its flashing to allow you to activate the
following features by simply pressing this key.
n When the smart function indicator
flashes rapidly, you can:
– Answer the call (outside call, intercom).
(page 16, 37)
– Stop the alarm sound. (page 26)
– Stop paging. (page 37)
n When the smart function indicator
flashes slowly in standby mode, you can:
– Read new SMS messages. (page 34)
– View the caller list when there are
missed calls. (page 31)
To activate these features, their Top key
setup must be "On". (page 14)
Using the smart function key
(Top Key)
When the smart function indicator flashes
rapidly/slowly, press MSmart functionN.
R The above features can be activated
depending the situation.
R If you answer a call using the smart
function key, the speakerphone is activated.
R Even if the handset is placed on the base
unit or charger, the feature can be
activated. You can talk without lifting up the
handset. If you want to perform further
operations, lift up the handset.
14
TG6711_51FX(en)_0803_ver101.pdf
R When the unit has new SMS messages
and missed calls, the unit can be operated
to show the new SMS messages first and
then show the missed calls.
Note:
R While key lock is on (page 18), incoming
calls can be answered, but the following
features are disabled even when the smart
function indicator flashes slowly.
– Read new SMS messages. (page 34)
– View the caller list when there are
Setting the smart function key (Top
Key Setup)
The Top key setup for the following features
must be "On".
– "New SMS" (Default: On)
– "Missed Call" (Default: Off)
The settings can be set for each handset.
1
2
MbN: Select the desired setting and press
R " " is displayed next to the selected
R To cancel a selected feature, press
3
Note:
R If the smart function indicator flashes when
the handset is not placed on the base unit
or charger, battery consumption is faster
than usual.

One touch eco mode

If you want to activate eco mode, set the
repeater mode "Off" beforehand (page 29).
When the handset is on the base unit, the
base unit transmission power is reduced up to
99.9 % if only one handset is registered.
Even when the handset is not on the base unit
or several handsets are registered, the base
unit transmission power in standby mode can
be reduced up to 90 % by activating one touch
eco mode.
14
missed calls. (page 31)
#278
.
features.
again. " " disappears.
a M N
2012/08/03 11:58:55