Table of Contents
Advertisement
4. Fax
4.4.2 Adding a new item into the broadcast
memory
After initial programming, you can add new items (up to
a combined total of 20).
1
Press {>}.
L Confirm that there are no documents in the
document entrance.
2
Press {A} or {B} repeatedly to display the desired
broadcast memory ("<BROADCAST1>",
"<BROADCAST2>" or "<MANUAL BROAD>").
3
Press {MENU}.
4
Press {*}.
5
Press {A} or {B} repeatedly to display the desired
item you want to add.
6
Press {SET}.
L To add other items, repeat steps 5 and 6 (up to
20 items).
7
Press {STOP} to exit.
Note:
L When adding new items to the MANUAL
BROADCAST memory, you can only select stored
items.
4.4.3 Erasing a stored item from the
broadcast memory
1
Press {>}.
L Confirm that there are no documents in the
document entrance.
2
Press {A} or {B} repeatedly to display the desired
broadcast memory ("<BROADCAST1>",
"<BROADCAST2>" or "<MANUAL BROAD>").
3
Press {MENU}.
4
Press {#}.
5
Press {A} or {B} repeatedly to display the desired
item you want to erase.
L To cancel erasing, press {STOP}.
6
Press {SET}.
7
Press {SET}.
L To erase other items, repeat steps 5 to 7.
8
Press {STOP} to exit.
4.4.4 Sending the same document to pre-
programmed parties
1
Insert the document FACE DOWN.
2
If necessary, press {A} or {B} repeatedly to select
the desired resolution (page 27).
3
Press the desired {BROADCAST} (1-2) or
{MANUAL BROAD}.
30
L The document will be fed into the unit and
scanned into memory. The unit will then send the
data to each party, calling each number
sequentially.
L After transmission, the stored document will be
erased from memory automatically, and the unit
will automatically print a report (broadcast
sending report).
Note:
L If you select "FINE", "SUPER FINE", "PHOTO" or
"MIXED" resolution, the number of pages that the
unit can send will decrease.
L If the document exceeds the memory capacity,
sending will be cancelled.
L If a party is busy or does not answer, it will be skipped
and redialled later up to 5 times.
To cancel broadcast transmission
1. Press {STOP} repeatedly until "SEND
CANCELLED?" is displayed.
2. Press {SET}.
Advertisement
Table of Contents
