Assembly; Caster Installation On Legs; Instructions For Oven Leg (Stand) Assembly; Figure 1, Stand Assembly - Market Forge Industries Standard Depth 8100 Owner's Manual

High efficiency gas convection oven standard depth/bakery depth

Table of Contents

DO NOT MOUNT oven on a curb base. Use legs/casters provided. Adequate air space at the bottom and

rear of the unit must be provided for proper venting of blower motor. DO NOT USE door to lift or move

oven!!! All ovens must be installed on leg assembly or casters shipped with the unit. The leg/stand

assembly parts or casters are shipped separately.

If casters are provided, match holes on the caster with holes on the oven bottom base and fasten with

bolts provided. NOTE: Front casters are locking type.

Assemble the leg assembly as follows: (For 8100 & 8300 Models Only)

1. Remove legs from package.

2. Line leg plate holes with holes at the bottom of the base.

3. Secure with (4) 3/8-16 bolts.

ASSEMBLY

Table of Contents

Bakery depth8392 Bakery depth8300 Standard depth8192 8100 8192 8300 ... Show all