Others Menu - Epson EB-925 User Manual

List of Functions

Others menu

Submenu
SNMP Set to On to monitor the projector using SNMP.
To monitor the projector, you need to install the SNMP manager
program on your computer. SNMP should be managed by a
network administrator.
The default value is Off.
You can register up to two IP addresses for the SNMP trap
Trap IP Address
notification destination. You can enter a number from 0 to 255 in
1/Trap IP Ad‐
each field of the address. However, the following IP addresses
dress 2
cannot be used. 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x
is a number from 0 to 255)
Priority Gateway You can set the priority gateway to a Wired LAN or Wireless
LAN.
(EB-925/
EB-915W/
EB-905/EB-96W/
EB-95 only)
Function
Submenu
AMX Device Dis‐ When the projector is connected to a network, set this to On
covery when you want to enable the projector to be detected by AMX
Device Discovery
environment controlled by a controller from AMX or AMX
Device Discovery.
Set this to On only when monitoring or controlling the projector
RoomView
over the network using Crestron RoomView
this to Off.
s "About Crestron RoomView
When this is set to On, the following functions are not available.
• Web control
• Message Broadcasting (EasyMP Monitor Plug-in)
Function
g
. Set this to Off if you are not connected to an
®
. Otherwise, set
®
" p.69
90