Alarm Control Functions - Panasonic WJ-FS616 Operating Instruction

5. Home Position Selection
The following functions are only available with cam-
eras that have preset panning functions, such as
the Panasonic WV-BS500 or WV-CS600 series.
1. Select the desired camera referring to Camera
Selection on page 50.
2. Press the HOME button to move the camera to the
home position.
HOME/–
AUX1
6. Camera Setup
1. Select the desired camera referring to Camera
Selection on page 50.
2. Press the CAMERA SET ON button to access the
Camera Setup Menu.
The display on the LCD changes as shown below.
SET UP
CAMERA
SET ON
REV T/L MODE
U01 C01 CamSet Up
F1 F2
3. Select an item by moving the joystick UP or DOWN.
Then select the mode by moving the joystick LEFT
or RIGHT.
4. Press the SET key to execute the setting or enter a
sub menu.
5. To return to the previous menu, press the UNIT/
ESC key.
6. Press the F3 button to reset the selected function,
or press F4 to reset all functions to the initial state.
7. Press the CAMERA SET OFF button to escape
from the setup mode or menu.
Note: Refer to the operating instructions of the
selected camera for more details.
• Simplified preset position setting
The preset position can be set by a simplified pro-
cedure without going through the position setting
menu.
The following functions are only available with cam-
eras that have preset panning functions, such as
the panasonic WV-BS500 or WV-CS600 series.
1. Press the ALT button while the position setting
menu is displayed.
2. Press the joystick controller to move the pan/tilt
head in the desired direction.
3. Press the FOCUS or ZOOM button to adjust
the lens to obtain the desired picture.
CAMERA
SET OFF
PLAY
RES A.RES
F3 F4
4. Press the ALT button again to restore the joy-
stick controller's cursor control function..
Caution: If the camera setup is started with the
buttons on the camera, all future settings must
also be made with these buttons.
If the camera setup is started from a controller,
all future settings must also be made from the
controller.
7. Auxiliary Control
The following function is available only with a sys-
tem that includes
Receivers.
1. Select the desired camera. Refer to the Camera
Selection on page 50.
2. While the ALT switch is on, press the AUX1 or
AUX2 button to turn enable or disable the user's
auxiliary switch in the Receiver.
ALT
Note: The auxiliary control is not available while
operating the zoom or pan/tilt head.
ALARM CONTROL
FUNCTIONS
Alarm Suspension
1. Press the RESET and EL-ZOOM buttons simultane-
ously for two seconds or longer to suspend the
alarm.
The LED on the RESET button lights up.
2. Press the RESET button again to reset the alarm
suspension.
The LED on the RESET button goes off.
-51-
WV-RC100 or WV-RC150
HOME/– AUTO/+
AUX1 AUX2
EL-
RESET
ZOOM
ALL FS
RESET