Multiscreen Output Menu - Panasonic WJ-FS616 Operating Instruction

9. Alarm Mode on Spot Monitor
This item lets you select the mode for displaying an
alarm on the Spot Monitor.
1. Move the cursor to the ALM MODE-SPT para-
meter.
2. Select the desired mode by pressing the LEFT
or RIGHT button. The initial factory setting is
ALM-SPOT mode.
ALM-SPOT: The picture of the camera that has
activated the alarm is displayed.
If multiple alarms are activated, the monitor
displays the camera picture that has acti-
vated the alarm most recently.
ALM-IGNORE: Displays the title of alarm on
the alarmed camera picture if that picture
is selected on the Spot Monitor.
10. Dynamic Recording
In this mode, the camera picture of the channel on
which the alarm was activated is recorded with
more fields than in normal recording mode.
This item lets you enable or disable dynamic
recording mode for recording on video tape.
1. Move the cursor to the DYNAMIC REC parame-
ter.
2. Select ON or OFF by pressing the LEFT or
RIGHT button. The initial factory setting is OFF.
ON: Enables dynamic recording.
OFF: Disables dynamic recording.
11. Alarm Recording Mode
This item lets you select the mode for recording an
alarm.
Refer to 4. Recording Mode on page 28 for more
details.
1. Move the cursor to the ALM REC MODE para-
meter.
2. Select the desired mode by pressing the LEFT
or RIGHT button. The initial factory setting is
MODE 0.
MODE 0: Normal Recording
MODE 1-8: Time Lapse mode without camera
switching pulse.
MODE9: Time lapse mode with camera switch-
ing pulse.
After finishing the setting, press the SETUP/ESC
button to return to the previous SETUP MENU.

Multiscreen Output Menu

WJ-FS616 SETUP MENU
ALARM SETUP *
MULTI OUTPUT SETUP *
SPOT OUTPUT SETUP *
REC/MULTI2
SYSTEM SETUP *
CAM DOWNLOAD
CAM UPLOAD
ALL RESET SELECT *
Move the cursor to MULTI OUTPUT SETUP on the
SETUP MENU, then press the SET button. The
MULTI OUTPUT SETUP menu appears on the mon-
itor screen as shown below.
These items let you determine the display mode of
the Multiscreen Monitor.
MULTI OUTPUT SETUP
TITLE DISPLAY
CLOCK DISPLAY
STILL DISPLAY
BORDER
DISPLAY POSITION *
SEQUENCE MODE
1. Camera Title Display Setting
This item lets you enable or disable display of the
camera title on the Multiscreen Monitor.
1. Move the cursor to the TITLE DISPLAY para-
meter.
2. Select ON or OFF by pressing the LEFT or
RIGHT button. The initial factory setting is ON.
ON: Enables display of the camera title on the
monitor screen.
OFF: Disables display of the camera title on
the monitor screen.
Note: Display position is fixed on the lower left
corner of the Multiscreen Monitor.
-25-
REC OUTPUT *
NO
NO
ON
ON
ON
WHITE
SEQ2