Table of Contents
Advertisement
2. ALARM BUZZER
The buzzer beeps when this unit receives the alarm
signal. You can adjust the buzzer time between 1
and 60 seconds by changing the ALARM BUZZER
parameter.
1. Move the cursor to the ALARM BUZZER parameter.
2. Select the buzzer time.
OFF: The alarm buzzer does not beep when the
alarm signal is received.
1-30, 60S: The buzzer keeps on beeping for the
duration you set. The letter "S" stands for sec-
onds.
The factory setting is 2S.
* MENU 1 OF 3 *
DYNAMIC REC
ALARM BUZZER
ALARM OUTPUT
REC MODE
3. ALARM OUTPUT
When alarm is received, the alarm signal is sup-
plied
to
the
other
ALARM/REMOTE connector.
duration the alarm signal is output between 1 and
60 seconds.
1. Move the cursor to the ALARM OUTPUT parameter.
* MENU 1 OF 3 *
DYNAMIC REC
ALARM BUZZER
ALARM OUTPUT
REC MODE
2. Select the duration the alarm signal is output.
1-30, 60S: The alarm signal is output for the dura-
tion you set. The letter "S" stands for seconds.
The factory setting is 2S.
OFF
2S
2S
4FIELDS
device
through
the
You can adjust the
OFF
2S
2S
4FIELDS
4. REC MODE
The recording mode can be set to 4-255 fields or
time lapse recording.
1. Move the cursor to the REC MODE parameter.
* MENU 1 OF 3 *
DYNAMIC REC
ALARM BUZZER
ALARM OUTPUT
REC MODE
2. Select the recording mode.
4-255 FIELDS: The output signal to be recorded on
the VTR is switched each time after the number
of fields you have set.
T/L: The recording output signal is supplied to the
VTR for time lapse recording.
The factory setting is 4 FIELDS.
Note:
When T/L is selected and no camera switching
signal supplied, there will be no correct time
lapse recording. In this case, either supply the
camera switching signal or select 4 - 255 fields
in REC mode for normal recording.
-9-
OFF
2S
2S
4FIELDS
Advertisement
Table of Contents
