Panasonic WJ-FS616 Operating Instruction page 41

3. Electronic Zooming
1. Repeat the procedures described above for Single
Spot.
2. Press the EL-ZOOM button to display the zoomed
picture.
The LED on the EL-ZOOM button lights up.
EL-ZOOM
ENTRANCE
ENTRANCE
3. Press the UP, DOWN, LEFT or RIGHT button to
move the picture in the desired direction.
Note: Operating these buttons beyond the picture
range activates control of the pan/tilt head.
4. To cancel this mode, press the EL-ZOOM button
again.
The selected camera picture is displayed in spot
mode, and the LED on the EL-ZOOM button goes
off.
Note: During zooming the picture, some noises
may appear on the right side of the screen.
4. Multi Spot
1. Repeat steps 1 and 2 described for Single Spot on
page 38.
2. Press the MULTISCREEN SELECT button repeat-
edly.
MULTISCREEN
SELECT
Each time the MULTISCREEN SELECT button is
pressed, the next of the 6 available multiscreens is
displayed as follows.
1 2
3 4
4 SEGMENT SCREEN
1 2
4 5
7 8
9 SEGMENT SCREEN
2
1
4
6 7 8
10 11 12
13 SEGMENT SCREEN
Notes:
• Blank channels are displayed in black.
• The display positions on each multiscreen are
fixed as shown above.
• Display positions may be assigned to each
area segment.
Position" on page 26.
5. Multi Still
1. Repeat steps 1 and 2 described for Single Spot on
page 38.
2. Press the MULTISCREEN button repeatedly to dis-
play the desired multiscreen.
The divided screens appear on the monitor screen.
3. Press the STILL button. The LED on the button
lights up.
4. Press the CAMERA button corresponding to the
picture you want to be stilled.
The LED on the pressed CAMERA button starts to
blink.
-39-
1 2
4
3
6
7 SEGMENT SCREEN
3
1
2
6
3 4 5
9
7 8 9
10 SEGMENT SCREEN
3 1 2 3
5 5 6 7
9 9 10 11
13 13 14 15
16 SEGMENT SCREEN
Refer to "Camera Display
5
7
6
10
4
8
12
16