Panasonic Viera TX-L37V20E Operating Instructions Manual page 71

■
WPS(Push button)
WPS(Push button)
1) Please press the 'WPS' buttton on the access
point until its light flashes.
2) When light is flashing select 'Connect' on TV.
If you are unsure, please check the instruction
manual of the access point.
Connect
■
Search for access point
Access points found automatically are listed.
Available Access Points
No. SSID Wireless type Encrypt Reception
1 Access Point A 11n(2.4GHz)
2 Access Point B 11n(5GHz)
3 Access Point C 11n(5GHz)
Encryption Key Setting
Connection will be made with the following settings:-
SSID : Access Point A
Authentication type : WPA-PSK
Encryption type : TKIP
Please input the encryption key.
Encryption key
Access Point Settings
Encryption key
A B C D E F G H I J K L M N O P Q R S T
U V W X Y Z 0 1 2 3 4 5 6 7 8 9 ! :
a b c d e f g h i j k l m n o p q r s
u v w x y z ( ) + - . * _
Access Point Settings
Encryption key is set to:-
XXXXXXXX
Select 'Yes' to confirm.
Select 'No' to change.
Yes No
■
WPS(PIN)
Available Access Points
No. SSID Wireless type Encrypt Reception
1 Access Point A 11n(2.4GHz)
2 Access Point B 11n(5GHz)
3 Access Point C 11n(5GHz)
WPS(PIN)
Please register the following PIN codes on the
access point.
PIN code : 12345678
Select 'Connect' after entering and saving
settings on the access point.
Connect
Press the WPS button on the access point until the light flashes.
And then, press the OK button to connect the Wireless LAN Adaptor and the
access point.
●
Ensure that your access point supports WPS for this setup.
●
WPS: Wi-Fi Protected Setup
Select your desired access point
access
select
: Encrypted access point
Access the encryption key input mode
●
If the selected access point is not encrypted, the confirmation screen will be
displayed. It is recommended to select the encrypted access point.
Enter the encryption key of the access point
Set characters one by one
#
t
select
set
●
You can set characters by using numeric buttons.
Select "Yes"
select
confirm
●
To re-enter the encryption key, select "No".
Select your desired access point
access
select
●
Ensure that your access point
supports WPS for this setup.
●
To search access points again
yellow
●
For the information of the
highlighted access point
●
To set manually
red
Enter the PIN code to the
access point, and then select
"Connect"
●
To search access points again
●
For the information of the
highlighted access point
●
To set manually
Store
BACK/
RETURN
■
Manual
You can setup SSID, authentication type,
encryption type, and encryption key manually.
Follow the on screen instructions and set
manually.
●
When you use 11n (5GHz) for the wireless
system between the Wireless LAN Adaptor
and access point, please select "AES" for
the encryption type.
Access Point Settings
Please input the SSID.
SSID XXXXXXX
SSID Setting
SSID is set to:-
XXXXXXX
Select 'Yes' to confirm.
Select 'No' to change.
Yes No
Authentication Type Settings
Connection will be made with the following settings:-
SSID : XXXXXXX
Please select the authentication type.
WPA2-PSK
WPA-PSK
Shared key
Open
yellow
red
71