Operation - Panasonic CZ-01ESM11P Operation Manual

OPERATION

OPERATION BY ZONE
(Fig. 4)
Flow of operation by zone
Call up the desired zone.
Set the control mode.
Set time No.
Set operation mode.
Set temperature.
Start operation.
Stop
1
Press the ZONE/GROUP
CHANGEOVER BUTTON, to call up
the display of zoning.
ZONE
MONITOR
00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15
1
2
3
4
2
Press the ADVANCE/ BACK-
WARD BUTTON, to select the zone
No. Holding it down will quickly
move the display.
3
Press the CONTROL MODE
BUTTON, to call up the desired code
No. (See page 24.) Following the
change, the display flashes.
Setting is not possible when using a data station
or parallel interface.
M
M
M
M
M
M
The display
" " of the
group set in
the display
zone lights
up.
4
Press the TIMER ON BUTTON.
Press the TIMER ON BUTTON within
10 seconds after the code No. is
displayed. The display stops flash-
ing and lights up solidly.
CODE
No.
(only in conjunction with the schedule
timer)
5
Press the TIME No. BUTTON, to
select the desired time No.. When
you change the setting, the display
flashes. If you don't wish to pro-
gram the NOITG time, set timer No.
to "—".
Check the timer No. of the schedule timer. If the
schedule timer is not programmed, set the
program in accordance with the instruction manual
of schedule timer.
6
Press the TIMER ON BUTTON,
to finalize the time No. The display
flashes, and then lights up solidly.
Press the TIMER ON BUTTON within
10 seconds after the time No. is
displayed.
The display returns to its original state after no
less than 10 seconds.
No.
7
Press the OPERATION MODE
SELECTOR BUTTON, to call up the
desired mode. If you don't wish to
execute the unified setting in the
zone, set it to " – – ". (See page 29
for further details.)
The display
CODE
returns to its
No.
original state
after no less
than 10
seconds.
No.
22