Panasonic CZ-01ESM11P Operation Manual page 11

SETTING OPERATION
MODE (Fig. 5)
● The Zone consists of the following
two cases.
A. Zone without display "
The group with master remote controller setting
exists in this zone.
Setting the master remote controller enables cool/
heat selection.
Operations other than cool/heat operations can
also be set for some operations. For further
details, see the list on the right.
B. Zone with display "
No group with master remote controller setting
exists in this zone.
The cool/heat selection is not available because
the master remote controller has not been set.
Some operations other than cool/heat operations
can be set. For further details, see the list in the
right.
See page 31 if the display "
1
Press the OPERATION MODE
SELECTOR BUTTON. Each time
you press this button, the display
rotates as shown on the right list.
NOTES
● During cool/heat operation, this central remote
controller enables FAN operation for each zone
even without setting the master remote controller.
Meanwhile, ventilation, ventilation/cleaning, etc. are
available, if UM etc. are connected with this unit in
the zone. See the operation manual provided with
the each unit.
● When the indoor unit is in heat operation, change
the setting to FAN operation through the central
remote controller; then, you can switch the fan
speed to the extremely low fan speed. Warm air
may blow if any other indoor unit belonging to the
same system is in heat operation.
● The indoor fan stops during defrost/hot start.
● DRY cannot be set from the central remote control-
ler.
27
● List of setting operation
"
"
" is flashing.
Note) In the above list, "
A:
Display Setting
M
M
M
❈ 1
M
M
M
❈ 1
M
❈ 1
M
— —
B:
Display Setting
M
M
M
M
M
M
❈ 1
M
❈ 1
M
— —
setting, while " " refers to the not acceptable
setting.
In the meanwhile, ❈1 and ❈2 refer to the
followings.
❈1: Setting may not be acceptable depending
on the type of indoor unit with which this
unit is connected.
Zones not displayed
Contents of setting
To be set by zone
To be set by zone
To be set by zone
To be set by zone
To be set by zone
To be set by zone
Select this display if you
don't wish to set by
zone.
Zones displayed
Contents of setting
❈ 2
To be set by zone
To be set by zone
Select this display if you
don't wish to set by
zone.
" refers to the acceptable