Group Monitoring; Temperature Setting - Panasonic CZ-01ESM11P Operation Manual

❈2: The group on FAN operation in the zone
performs the temperature control opera-
tion (cool/heat) under the outdoor
refrigerant system.

TEMPERATURE SETTING

(Fig. 6)
1
Press the TEMPERATURE SET-
TING BUTTON.
Each time you press the "
temperature rises by 1
Each time you press the "
temperature falls by 1
If you don't wish to set the tempera-
ture in a unified manner in the zone,
set the temperature to " – – ".
NOTES
● The setting temperature refers to that of the
temperature sensing part. (It may differ from
the room temperature.)
● The proper setting temperature is 26 – 28°C
during cooling operation, and 18 – 23°C during
heating operation.
● The setting temperature is not displayed in the
FAN mode and Ventilation/Cleaning mode. The
set temperature is not displayed either if UM
etc. form a zone without an air conditioner.
If you wish to set the temperature to
" – – "
No.
Set the temperature at the point 1°C higher than the
upper limit and 1°C lower than the lower limit of the
range subject to setting, respectively.
L
", the
°
C.
M
", the
°
C.
(Example)
In case where the range of
temperature to be set is 16
– 32°C
M
Press the " " when the
display shows 16°C. The
display " – – " appears.
L
Press the " " when the
display shows 32°C. The
display " – – " appears.

GROUP MONITORING

(Fig. 7)
Utilize the group monitor function in each of the
following cases:
1. Check the malfunction code. (See the next
page.)
2. Check the group that requires cleaning of the
air filter and air cleaner element. (See page
30.)
3. Change the setting of the master remote
controller. (See page 29.)
4. Check the group(s) sharing the same outdoor
unit. Or, check the particular group(s) with the
master remote controller setting. (See page
30.)
5. Check the conditions of other individual
groups.
1
Press the ZONE/GROUP
CHANGEOVER BUTTON on the
display of zoning, and the display
"group" appears.
Unless operated from within one minute from
when the display of zoning appears, the display
will automatically revert back to the "group"
display.
2
Press the ADVANCE/BACK-
WARD BUTTON to set the group No.
Then, operation monitor display
" " of group No. lights up in the
displayed zone; then, the state of
the above group(s) is displayed in
the liquid crystal display.
28