Operations Before Replacing Any Part; Cms Part Replacement Operation - Konica Minolta BIZHUB PRO C6500 Replacement Instructions Manual

Introduction

Operations before replacing any part

7 CAUTION
Ignoring this cautions could cause injury or damage to property.
% Do not ignore these safety advices.
Warning
When conducting a part replacement operation, be sure to get
guidance from the customer engineer. And also, read the CMS
Replacement Instructions carefully before conducting a part re-
placement operation by following the prescribed procedure and
using tools also prescribed. Be sure not to conduct any opera-
tions other than those described in the CMS Replacement In-
structions. When the prescribed procedure and tools are not
employed, this may cause damage to the copier or you may get
injured.
Before starting operations, be sure to unplug the power cords
of the copier main body and the optional equipment from the
power outlet.
When the power cord is plugged into the power outlet, some
electrical components may be energized even if the power
switch is turned off. So, be careful not to get an electric shock.
The temperature gets high in the vicinity of the fusing unit. Be
careful not to come into contact with it, or you may get burned.

CMS part replacement operation

7 WARNING
Ignoring this warnings could cause serious injury or even death.
% Do not ignore these safety advices.
Warning
Do not allow any metal parts such as clips, staples and screws
to fall into the inside or opening of the copier.
They may cause a short circuit to the internal parts of the copier,
thus leading up to a risk of an electric shock or fire.
Check the wiring harness for squeezing and any other damage.
Current may leak, thus leading up to a risk of an electric shock
or fire.
bizhub PRO C6500 / bizhub PRO C6500e
Symbol
Symbol
1
1-5