Multi-Unit Operation; Operating Additional Units; Registering A Handset To A Base Unit - Panasonic KX-TCD220G Operating Instructions Manual

TCD220G(e-g).book Page 48 Thursday, January 20, 2005 11:43 AM

Multi-unit Operation

Operating additional units

Additional handsets
Up to 6 handsets can be registered to a single
base unit. Additional handsets will give you the
freedom to, for example, have an intercom call
with another handset while a third handset is on
an outside call. See Seite 5 for information on
ordering additional handsets.
Wichtig:
L The additional handset model recommended
for use with this unit is noted on Seite 5. If other
model handset is used, certain operations
(handset settings, base unit settings, etc.) may
not be available.
Additional base units
Handsets can be registered to up to 4 base units,
allowing you to add additional base units and
extend the area in which your handset(s) can be
used. If a handset moves out of range of its base
unit when "Automatisch" is selected on base
unit selection (Seite 49), it will look for another
base unit to make or receive calls. A base unit
and the handsets it communicates with is called a
"radio cell".
Hinweis:
L Calls will be disconnected when the handset
moves from one radio cell to another.
L Intercom calls and call transfers are only
possible between handsets in the same radio
cell.
Registering a handset to a
base unit
To register an additional handset to a base
unit (easy registration)
The included handset and base unit are
preregistered. After purchasing an additional
handset, register it to the base unit. Ensure that
the additional handset is switched on. If it is not
on, press and hold {ih} for few seconds to turn
the handset on.
48
1
Lift the additional handset and press {ih}
to put the handset in standby mode.
2
Press and hold {x} on the base unit for
about 3 seconds, until the registration tone
sounds.
3
Place the additional handset on the base
unit. The registration tone continues to
sound. With the handset still on the base
unit, wait until a confirmation tone sounds
and w stops flashing.
Hinweis:
L If an error tone sounds, or if w is still flashing,
register the handset manually (manual
registration; Seite 48).
L If all registered handsets start ringing in step 2,
press {x} to stop. Start again from step 1.
L Charge the batteries of your additional handset
for about 7 hours before initial use.
L This registration method cannot be used for
handsets that have already been registered to
a base unit. Register the handset manually
(manual registration; Seite 48).
To register a handset to an additional base
unit (manual registration)
You can register a handset to a base unit
manually using the following method.
1
Press {j/OK}.
2
Select "Mobilteileinst.", then press
{>}.
3
Select "Registrierung", then press {>}
2 times.
4
Select a base unit number, then press {>}.
L This number is used by the handset as a
reference only.
5
Press and hold {x} on the base unit for
about 3 seconds, until the registration tone
sounds.
L If all registered handsets start ringing,
press {x} to stop, then repeat this step.
L After pressing {x}, the rest of this
procedure must be completed within 1
minute.
6
Wait until "Basis PIN Eing." is
displayed, then enter "0000" (default base
unit PIN), then press {j/OK}.