Panasonic CS-W24BD2P Operating Instructions Manual page 12

Problem
Indoor unit does not operate when a
button is pressed.
Symptom
The unit does not cool or heat
properly.
If the CHECK display on the wired remote control display is flashing
Stop the indoor unit and check the conditions. After three minutes, start the operation again.
■ If the display still flashing
Display
AIR SWING TIMER
CHECK
LOCAL
OFF / ON
TIMER
SELECT
SET
TEST RUN CLOCK CANCEL
A/C No.
• The air conditioner No. "01" appears during normal
installation and use. When using group control, a different
number may appear.
Check the following before calling for servicing
Cause
• Is there a power outage?
• Is the circuit breaker on?
Cause
• Check whether an appropriate
operation mode is selected?
• Is anything blocking the inlet or outlet
vents of indoor or outdoor unit?
• Is the air filter soiled or dusty?
• Check if doors or windows have been
opened and closed frequently, or
whether heat-operating equipment
such as gas stoves and irons are
being used in the same room.
OPE-
FAN
RATION TEMP
SPEED
MED
COOL
FAN OPE- TEMP
UP
SPEED RATION
DOWN
FILTER
CHECK A/C No.
RESET
Press the CHECK button.
AIR SWING TIMER
CHECK
LOCAL
The timer display will change.
F15 ~ F49 will appear in place of the time. (The temperature
setting display will also change to show the air conditioner
number.)
(Example)
AIR SWING TIMER
CHECK
LOCAL
Please engage an authorized dealer for the malfunction
details.
– 11 –
Solution
Turn off the operation button once, then
turn it on again.
If the circuit breaker is off, turn it on.
Reference
Refer to page 10 for proper use details.
Remove any obstacles.
Refer to page 9,10 for maintenance
details.
Refer to page 10 for proper use details.
OPE-
FAN
TEMP
RATION
SPEED
MED
COOL
OPE-
FAN
RATION TEMP
SPEED
A/C No.