Buffered Scans Selection; Code I.d. Transmit Selection; Aim I.d. Transmit Selection; Function Code Transmit Selection - Hand Held Products Scanteam 5700 User Manual

Buffered Scans Selection

When enabled, this selection allows the scanner to accept a second scan while
the current scan is transmitted to the host terminal (buffering of scanned data).
When disabled, the scanner cannot accept additional scans until the current
scan is transmitted to the host. Default = Enable.
✱
Enable

Code I.D. Transmit Selection

This allows you to enable or disable transmission of a Code I.D. before the
decoded bar code symbology. (See the Symbology Chart on page 2–7 for the
single character code that identifies each symbology.)
Enable

AIM I.D. Transmit Selection

This selection allows you to enable or disable transmission of an AIM I.D. before
the decoded bar code symbology.
Identifiers for more information on the AIM symbology ID characters.) Default
= Disable.
Enable

Function Code Transmit Selection

When this selection is enabled, and function codes are contained within the
scanned data, the scanner transmits the key code (which corresponds to the
decoded ASCII function code) to the terminal. ASCII function codes are
represented by the HEX values 00–1F. (Charts of these function codes are
shown in Section 6, Supported Interface Keys.)
✱
Enable
2–10 SCANTEAM 5700 User's Guide
Disable
✱
Disable
(See AIM Guidelines on Symbology
✱
Disable
Disable