Drive Letter Conflict (Windows Operating Systems) - Kingston Technology DataTraveler 4000 User Manual

Drive Letter Conflict (Windows Operating Systems)

As mentioned in the 'System Requirements' section of this manual (on page 3), the DT4000
requires two consecutive drive letters AFTER the last physical disk that appears before the
'gap' in drive letter assignments (see
because they are specific to user-profiles and not the system hardware profile itself, thus
appearing available to the OS.
What this means is, Windows may assign the DT4000 a drive letter that's already in use by a
network share or Universal Naming Convention (UNC) path, causing a drive letter conflict. If
this happens, please consult your administrator or helpdesk department on changing drive
letter assignments in Windows Disk Management (administrator privileges required.)
In this example, the DT4000 uses drive F:, which is the first available drive letter after drive E:
(the last physical disk before the drive letter gap.) Because letter G: is a network share and
not part of the hardware profile, the DT4000 may attempt to use it as its second drive letter,
causing a conflict.
If there are no network shares on your system and the DT4000 still won't load, it is possible
that a card reader, removable disk, or other previously-installed device is holding on to a drive-
letter assignment and still causing a conflict.
Please note that Drive Letter Management, or DLM, has improved significantly in Windows XP
SP3, Vista, and 7, so you may not come across this issue, but if you are unable to resolve the
conflict, please contact Kingston's Technical Support Department for further assistance.
Document No. 48000127-001.A01
.) This does NOT pertain to network shares
Figure 10.5
Figure 10.5 – My Computer
®
DataTraveler 4000 Page 22 of 22