English - Kenwood CM370 series User Manual

safety
G Watch out for steam, never lift the
tank lid during the brewing cycle.
G CM370 series only: never touch
the hotplate.
G Always lift the lid using the lid
opening lip.
Keep children away from the
G
machine. And never let the cord
hang down where a child could
grab it. Push excess cord inside the
back of the machine.
Never use a damaged machine. Get
G
it checked or repaired: see 'service'.
Never put the machine in water or
G
let the cord or plug get wet - you
could get an electric shock.
Unplug:
G
before filling with water
G G
before cleaning
G G
after use.
G G
Never leave the machine on
G
unattended.
Don't let the cord touch hot parts.
G
Don't let infirm people use the
G
machine without supervision.
Don't let children play with this
G
machine.
Only use the machine for its
G
intended domestic use.
Always make sure there is water in
G
the tank before switching on.
This coffee maker is only suitable for
G
use with the type of carafe supplied.
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your machine.
G
This machine complies with
European Economic Community
Directive 89/336/EEC.
before using for the first time
1 Remove all packaging.
2 Wash the parts: see 'care and
cleaning'.
3 Push excess cord inside the back of
the machine.
4 Run two lots of water through the
machine (without coffee) to clean it
out. Fill the tank to the top cup mark
when you do this. See 'to make
coffee'.
key
water filter
water filter holder
removable water tank
lid
compartment for excess cord
on/off switch with indicator light
hotplate (model CM370 series only)
anti drip activating device
glass carafe and lid
(model CM370 series only)
thermal carafe and lid
(model CM380 series only)
measuring spoon
filter holder
permanent coffee filter (or use a
paper filter instead)
lid opening lip
aroma control
to make coffee
1 Lift the lid.
2 Lift out the water tank from the
coffee maker.
3 Separate the water filter holder by
pulling the unit apart and place the
water filter inside. Fit the unit back
together.
4 Turn the handle on the water filter
holder and align the arrow on the
base with the letter for the current
corresponding month eg F for
February.
5 Lower the water filter holder into the
water tank and fit into position in the
recess.
6 Fill the tank with the desired amount
of water. The water must be
between the top and bottom cup
marks. Do not fill above the MAX
level. (Alternatively fill the water tank
when fitted inside the coffee maker
but take care not to cause spillage.)
2