Kettler MONDEO Assembly Manual page 3

wn in the diagram inset. Use the fastening material exactly as
instructed. The required tools are supplied with the equipment.
Bolt all the parts together loosely at first, and check that they
have been assembled correctly. Tighten the locknuts by hand
until resistance is felt, then use spanner to finally tighten nuts
completely against resistance (locking device). Then check that
List of spare parts page 10-12
When ordering spare parts, always state the full article number,
spare-partnumber, the quantity required and the S/N of the pro-
duct (see handling).
Example order: Art. no. 07852-690 / spare-part no. 91170500
/ 2 pieces / control number/ S/N .................... Please keep
original packaging of this article, so that it may be used for trans-
port at a later date, if necessary.
Important: spare part prices do not include fastening material; if
fastening material (bolts, nuts, washers etc.) is required, this
all screw connections have been tightened firmly. Attention:
once locknuts have been unscrewed they no longer function
correctly (the locking device is destroyed), and must be repla-
ced.
For technical reasons, we reserve the right to carry out preli-
minary assembly work (e.g. addition of tubing plugs).
should be clearly stated on the order by adding the words „with
fastening material".
KETTLER International Inc.
1355, P. B. 2747 · Virginia Beach · VA 23450 USA
http://www.kettlerusa.com
3