Safety; Before Plugging In - Kenwood Frothie CL420 series User Manual

before using your Kenwood
appliance
G
Read these instructions carefully and
retain for future reference.
G
Remove all packaging and any
labels.

safety

G
Switch off and unplug:
before fitting and removing parts
G G
after use
G G
before cleaning.
G G
G
Never immerse the goblet or
allow the underside to get
wet. Dry thoroughly before
use.
G
Do not overfill as hot liquid may
splash out during the blending
operation.
G
Never let the power unit, cord or
plug get wet.
G
Keep hands and utensils out of the
goblet when it's on the power unit.
G
Never use a damaged appliance.
Get it checked or repaired : see
'service'.
G
Never use an unauthorised
attachment.
G
Never leave the appliance on
unattended.
G
When removing the goblet from the
power unit, wait until the paddle has
completely stopped.
G
Do not operate the appliance whilst
the goblet is empty.
G
Only operate the appliance with the
lid in place.
G
Only use the power unit supplied
and keep it clean and dry.
G
Beware, the appliance will get hot
during operation.
G
Keep small children away from the
appliance and never let the cord
hang down over the worktop edge -
a small child could grab it and pull
the appliance down.
G
Take care when drinking liquids as
they will be hot.
G
Keep hot drinks out of childrens
reach.
G
Don't drink while holding your baby.
If you're passing someone a drink,
make sure a child isn't underneath.
G
Do not let infirm people use the
appliance without supervision.
G
Do not let children use or play with
the appliance.
G
Only use the appliance for its intended
domestic use. Kenwood will not accept
any liability if the appliance is subject to
improper use, or failure to comply with
these instructions.

before plugging in

G
Make sure your electricity supply is
the same as the one shown on the
underside of the machine.
Important – UK only
G
The wires in the cord are coloured
as follows:
Green and Yellow = Earth,
Blue = Neutral,
Brown = Live.
G
The appliance must be protected by
a 13A approved (BS1362) fuse.
G
WARNING: THIS APPLIANCE
MUST BE EARTHED.
Note:
G
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
G
If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
G
The machine complies with
European Economic Community
Directive 89/336/EEC.
2