To Use Your Frothie; Key - Kenwood Frothie CL420 series User Manual

before using for the first time
1 Wash the parts: see 'cleaning'.
2 Wrap excess cord around the cord
storage device on the underside of
the appliance.

key

lid
goblet
paddle
tap assembly
drive
power unit
brush

to use your Frothie

1 Make sure the tap is correctly
assembled to the goblet, then place
on the power unit.
G
Check that the dispensing tap lever
is in the off position
2 Always place the liquid ingredients
into the goblet first.
3 Then add the soluble ingredients eg.
powdered hot chocolate, cocoa,
malted drinks, coffee powder etc., or
chopped chocolate.
Note:
This appliance is not designed to be
a blender/liquidiser or to chop solid
ingredients. Ingredients for flavouring
purposes such as cloves and
cinnamon sticks may be used but
will need to be dispensed through a
strainer before serving.
4 Fit the lid to the goblet so that the
spout is covered.
5 Press the 'Heat & Mix' button, the
mixing and heating operation will
start straight away. The appliance
will automatically stop when the
correct temperature has been
reached.
6 Place a cup under the tap, press the
'Frothy Mix' button and pull forward
the dispensing tap lever.
.
3
G
Using the 'Frothy Mix' button to
dispense drinks will make the drink
frothier and also help to dispense
thicker drinks.
7 When the cup is almost full, release
the lever to its off position and
switch off by pressing the 'off'
button.
hints
G
For best results the drink should be
consumed straight away.
G
For extra richness, swirl some fresh
cream on top of hot sweet drinks or
add a dollop of freshly whipped
cream.
G
The maximum capacity of the
Frothie is 1.2 litres and the minimum
200ml. A 1 litre mixture will be ready
in approximately 9 minutes.
G
If the goblet doesn't fit easily to the
power unit, lift off and turn the drive
on the power unit and re-fit.
G
Your Frothie will also mix cold
milkshakes. Pour the cold milk into
the goblet then add the liquid or
powder flavouring/concentrate and
press the 'Frothy Mix' button. Allow
to operate for 1 minute then place a
cup under the tap, pull forward the
dispensing tap lever. When the cup
is almost full, release the lever to its
off position and switch off by
pressing the 'off' button.
G
At anytime during the mixing and
heating operation, you may switch
off the Frothie by pressing the 'off'
button.
important
G
The base of the goblet is fitted
during manufacture and no attempt
should be made to remove it.
G
Don't use the goblet as a storage
container. Keep it empty before and
after use.
G
Some liquids increase in volume and
froth during blending eg milk, so do
not overfill and ensure the lid is
correctly fitted.