Built-in dmx – built-in freezefog connection
built-in pre-delay for freezefog use
2kw, single pipe, large mass heat exchanger
optional, variable, 200w fan drive output (8 pages)
Introduction The Battle Fogger is a Microprocessor Controlled, Water Base Fog generating system. Microprocessor Control The Microprocessor is responsible for the following control elements - Monitoring the heat exchanger temperature. Driving the heater within the heat-exchanger. Driving the fluid pump unit, relating fluid flow to temperature Accepting and manipulating data from the Flow, Duration and Interval controls.
Warning IMPORTANT SAFETY INSTRUCTIONS Do not touch or place hands, expose skin, within 50 cm. of discharge nozzle. SAVE THESE INSTRUCTIONS READ THESE IMPORTANT SAFETY INSTRUCTIONS WARNING READ THESE IMPORTANT SAFETY INSTRUCTIONS Do not remove the outer case until power has been disconnected from the machine READ THESE IMPORTANT SAFETY INSTRUCTIONS Persons suffering from asthma or allergenic...
Technical Specifications: Model: Battle Fogger Type: Water Base Fog generating system Size: Height: 9 1/2” 24 cm. Width: 9 3/8 23.8 cm. Length:22 1/2 57.1 cm. Net Weight: 11.3 Kg. 25 lbs. Weight With Fluid 15.8 Kg. 35 lbs. Power Rating: 110 Volt A.C.
15 Amps. The supply should be ‘clean’ and free of interference. Open a container of Le Maitre fog fluid , remove cap and break foil seal (if provided). Remove Cap from Battle Fogger fluid resevoir. Fill with fluid, being careful not to overfill resevoir.
Solid Led: Indicates that the unit is ready to fog at full output. No Illumination: Problem. Check Remote Handset connection on the rear panel of Battle Fogger. If this fails to correct the problem, contact your local Le Maitre dealer. Remote and External Control Features...
Battle Fogger Tube Change Procedure Caution ! The block contains extremely hot surfaces and liquids. These will cause severe burns on contact. Please unplug power to eliminate electrocution hazard and allow the unit to cool before attempting to service the block.
13. Plug the machine in and allow it to come to full heat. You are now ready to fog away! Maintenance Exterior: The casing of the Battle Fogger is steel with a powder paint coating. To clean simply wash with mild soap and warm water. Heat Exchanger: With normal use we do not recommend flushing or cleaning the heat exchanger, with the use of genuine Le Maitre fluids.
Recommended Fluids Fog Fluid This fluid has been our long standing blend. It is a clean, white, practically odourless fog. It is used for many applications where a cloud of fog is required with a medium hang time. Pro Beam (Long Lasting )Fluid This is a brand new blend.
Maxi Fog Fluid was developed for our high volume users requiring an excellent balance of price and performance without compromise. All of our Fog Fluids are water base and leave NO residue. Permanent damage will occur if Haze Fluid is used in Battle Fogger for any length of time. Warranty Warranty: All warranty is one year parts and labour unless specified and is on manufac- turer defect only.
2. Do not modify the machine or use a machine which has been damaged in any way. 3. Allow sufficient air circulation around the machine at all times. 4. Protect the Battle Fogger from direct weather effects and wet locations. 5. Only use fluids recommended by the Le Maitre Special Effects.
Need help?
Do you have a question about the Battle Fogger and is the answer not in the manual?
Questions and answers