Introduction The Show Fogger Pro is a Microprocessor Controlled, Water Base Fog generating system. Microprocessor Control The Microprocessor is responsible for the following control elements - Monitoring the heat exchanger temperature. Driving the heater within the heat-exchanger. Driving the fluid pump unit, relating fluid flow to temperature Accepting and manipulating data from the Flow, Duration and Interval controls.
Warning Important Safety Instructions: Do not touch or place hands, expose skins, within 50 cm. of discharge nozzle. Important Safety Instructions: Do not remove the outer case until power has been disconnected from the machine. Important Safety Instructions: Persons suffering from asthma or allergenic sensitivity may experience irritation, discomfort, or allergic symptoms when exposed to fog effects.
Technical Specifications Model: Show Fogger Pro Type: Water Base Fog generating system Size: Height: 9 1/2” 24 cm. Width: 9 3/8 23.8 cm. Length:22 1/2 57.1 cm. Net Weight: 11.3 Kg. 25 lbs. Weight With Fluid 15.8 Kg. 35 lbs.
15 Amps. The supply should be ‘clean’ and free of interference. Open a container of Le Maitre fog fluid , remove cap and break foil seal (if provided). Remove cap from Show Fogger Pro fluid resevoir. Fill with fluid, being careful not to overfill resevoir.
Le Maitre dealer. Remote and External Control Features External Remote Connector The standard Remote Handset cable may be extended from the machine, and operated effectively away from the Show Fogger Pro. The maximum recommended cable length is 200 Feet. lemaitrefx.com...
Show Fogger Tube Change Procedure The block contains extremely hot surfaces and liquids. These will cause severe burns on contact. Please unplug power to eliminate electrocution hazard and allow the unit to cool before attempting to service the block. 1. Remove the six screws from the case. Four are under the lip at mid level and two are on top.
13. Plug the machine in and allow it to come to full heat. You are now ready to fog away! Maintenance Exterior: The casing of the Show Fogger Pro is steel with a powder paint coating. To clean simply wash with mild soap and warm water. Heat...
Recommended Fluids Directors’s Choice Fog Fluid: This fluid has been our long standing blend. It is a clean, white, practically odourless fog. It is used for many applications where a cloud of fog is required with a medium hang time. Pro Beam (Long Lasting) Fog Fluid: We have had many compliments on our fog fluid but many of our customers would like it to hang longer so we introduced the “Long Lasting Fluid”.
Any product not returned within 30 days is considered purchased. Warning: Le Maitre Special Effects Inc. considers all it's product to be safe for use in the application it was intended. Le Maitre Special Effects takes no responsibility for misuse or incorrect use. Always refer to equipment owners manual for proper use.
2. Do not modify the machine or use a machine which has been damaged in any way. 3. Allow sufficient air circulation around the machine at all times. 4. Protect the Show Fogger Pro from direct weather effects and wet locations. 5. Only use fluids recommended by the Le Maitre Special Effects.
Need help?
Do you have a question about the Show Fogger Pro and is the answer not in the manual?
Questions and answers