Advertisement
Le Maitre's
G300MkIII
Operating Manual
High Continuous Output Capability
Quieter Smoke Output Performance
New Digital Control Panel with Memory
Built-in DMX – Built-in Freezefog Connection
Built-in Pre-Delay for Freezefog use
2Kw, Single Pipe, Large Mass Heat Exchanger
Optional, Variable, 200W Fan Drive Output
Advertisement
Table of Contents
Related Manuals for Le Maitre G300MkIII
Summary of Contents for Le Maitre G300MkIII
- Page 1 Le Maitre’s G300MkIII Operating Manual High Continuous Output Capability Quieter Smoke Output Performance New Digital Control Panel with Memory Built-in DMX – Built-in Freezefog Connection Built-in Pre-Delay for Freezefog use 2Kw, Single Pipe, Large Mass Heat Exchanger Optional, Variable, 200W Fan Drive Output...
- Page 2 Safety and Cautions All electro-mechanical machines have the ability to cause injury, either mechanically or electrically. The user should be fully aware of the correct operational procedures involved in the use of this machine, and should feel comfortable about being in control of it. All users should make themselves aware of any national or local restrictions in the use of these types of machines in applications involving public venues or areas.
- Page 3 Any spillage should be cleaned away. The fluid does not require anything other than a water-based cleanser. THE G300MkIII should not be run without fluid for any length of time as this will cause pump failure. Fluid pump priming should be performed at the maximum smoke output, to ensure a quick and air lock-...
- Page 4 ‘normal temperature’ - non smoke re-circulation area. IMPORTANT Major problems will occur if the G300MkIII is left in areas where there is no air circulation or where the machine’s own issued smoke is drawn directly back into it. If the machine has to be installed in situations such as this, it is strongly advised that an auxiliary fan is used to ensure air flow around the machine and to prevent ingress of the machine’s own...
- Page 5 ‘Up’ and ‘Down’ buttons will adjust the setting. If held down, they will auto-step. Pressing ‘Manual’ and ‘Store’ together will memorise the setting for when the G300MkIII is next switched on. The ‘Store/DMX’ led reacts and blinks when a new value is stored.
- Page 6 How to set the DMX mode of operation as standard from ‘power on’ Disconnect all DMX signal leads from the G300MkIII. Select DMX mode and the status LED should be blinking. Now press the DMX and STORE buttons and wait for the Status LED to blink quickly several times. Check by turning the machine Off then On again.
- Page 7 Le Maitre® fluid. Le Maitre® Ltd considers all of its products to be safe for use in the application for which they are intended. Le Maitre® Ltd takes no responsibility for misuse or incorrect use. Always refer to the equipment owner’s manual for proper use, and be aware of local legislation governing the products use.
Need help?
Do you have a question about the G300MkIII and is the answer not in the manual?
Questions and answers