Assembly - Bounty Hunter Pioneer 505 Owner's Manual

EASY ASSEMBLY
Assembly is easy and requires no tools.
G
1
Position detector upright.
G
2
Rotate
COLLAR fully in a counter
clockwise direction.
G
3
Insert your finger inside the
tube and make sure the
INTERNAL CAM LOCK is
flush with the inside of the
tube.
G
4
Insert the LOWER STEM into
the S-ROD.
G
5
Rotate the LOWER STEM until the SILVER BUTTON locates in the hole.
G
6
Twist the LOCKING COLLAR fully in the clockwise direction until it locks.
G
7
If your detector has 3 tubes and 2 locking collars, repeat this process
on the Middle Stem.
G
8
Position the Lower Stem (the straight tube) with the Silver Button
toward the back.
Searchcoil to the plastic extension protruding from the Lower Stem.
G
9
Press the button on the upper end of the Lower Stem, and slide the
Lower Stem into the S-Rod.
Adjust the Stem to a length that lets
you maintain a comfortable upright
posture, with your arm relaxed at
your side, and the Searchcoil parallel
to the ground in front of you.
G
1 0
Wind the Cable securely around the
Stem.
G
1 1
Insert the Plug into the matching
Connector on the right underside of
the Detector Body. Be sure that the
key-way and pins line up correctly.
Caution:
Do not force the plug in. Excess
force will cause damage.
To disconnect the cable, pull on
the plug.
Do not pull on the cable.
4
the LOCKING
Using the Bolt and Knurled Knob, attach the
S-ROD
S-ROD
Connector
on back of
unit Body
Connector
LOCKING
COLLAR
INTERNAL
CAM LOCK
SILVER BUTTON
MIDDLE
STEM
MIDDLE STEM
Plug
Detector
Body
S-Rod