Screen - Palm TREO PRO User Manual

charge your smartphone (and not to sync),
you need to turn off setup mode. When the
Setup screen appears on your computer,
on your smartphone, press Cancel (right
softkey), and then press Exit (right
softkey).

Screen

The screen appears blank
1 If this is the first time you are turning on
your smartphone, you need to take out
and reinsert the battery to turn on the
screen (see Replacing the battery).
Alternately, connect your smartphone to
a wall outlet using the USB AC charger
(see Charging the battery).
2 If you're on a call, when the time period
specified in Backlight Settings expires,
the screen dims; one minute later, the
screen automatically turns off.
Press any key except End to wake up
the screen. Pressing End hangs up the
call.
3 Look closely at the screen. If you can
see a dim image, try adjusting the
screen brightness (see Adjusting the
brightness).
4 If that doesn't work, perform a soft
reset (see Performing a soft reset).
5 If that doesn't work, connect your
smartphone to the USB AC charger (see
Charging the battery) and perform a soft
reset again.
6 If you are using a third-party application,
make sure that the application supports
320x320 screen resolution.
7 If that doesn't work, perform a hard
reset (see Performing a hard reset).
The screen doesn't respond accurately to
taps or activates wrong features
1 Make sure there is no debris trapped
under the edges of the screen.
2 Press Start and select Settings.
3 Select the System tab, and then select

Screen

.
4 On the General tab, select Align
Screen.
5 Tap the screen where indicated.
6 Press OK .
T R O U B L E S H O O T I N G
S C R E E N
14
313