Maytag MDG18CSAW Installation Instructions Manual page 7

Commercial dryer gas or electric
Table of Contents

Advertisement

Available languages

Available languages

GAS DRYER iNSTALLATiON REQUIREMENTS
Location Requirements
Explosion Hazard
Keep flammable materials
and vapors, such as
gasoline, away from dryer.
Do not install in a garage.
Failure to do so can result in death, explosion, or fire,
Your dryer can be installed
in a basement,
laundry room, or
recessed
area.
Companion
appliance
location
requirements
should also be
considered.
IMPORTANT:
Do not install or store the dryer where it will be
exposed
to the weather.
Proper installation
is your responsibility.
You will need:
[]
A grounded
electrical
outlet located
within 6 ft. (1.8 m) of
where the power
cord is attached
to the back of the dryer.
See "Electrical
Requirements_'
[]
A level floor with a maximum
slope of 1" (25 mm) under entire
dryer. Installing
the dryer on soft floor surfaces,
such as carpets
or surfaces
with foam backing,
is not recommended.
Gas dryer
installation
clearances
[]
The location
must be large enough to allow the dryer door
to be fully opened.
[]
Additional
spacing
should
be considered
for ease of installation
and servicing.
The door opens more than 180 °.
[]
Additional
clearances
might be required
for wall, door, and floor
moldings.
[]
Additional
spacing
of 1" (25 mm) on all sides of the dryer
is recommended
to reduce
noise transfer.
When installing
a gas dryer:
I M PORTANT:
Observe
all governing
codes and ordinances.
[]
Check code requirements:
Some
codes limit or do not
permit
installation
of clothes
dryers
in garages,
closets,
or sleeping
quarters.
Contact
your local building
inspector.
[]
Make sure that lower edges of the cabinet,
plus the back and
bottom
sides of the dryer, are free of obstructions
to permit
adequate
clearance
of air openings
for combustion
air. See
"Recessed
Area and Closet
Installation
Instructions"
below for
minimum
spacing
requirements.
Recessed
Area and Closet
Installation
Instructions
This dryer may be installed
in a recessed
area or closet.
For
recessed
area and closet
installations, minimum
clearances
can be found on the warning
label on the rear of the dryer
or in "Dimensions/Clearances:'
The installation
spacing
is in inches and is the minimum
allowable.
Additional
spacing
should
be considered
for ease of installation,
servicing,
and compliance
with local codes and ordinances.
If closet door is installed, the minimum
unobstructed
air opening
in
the top and bottom
is required.
Louvered
doors with equivalent
air
openings
are acceptable.
The dryer must be exhausted
outdoors.
No other fuel-burning
appliance
may be installed
in the same closet
as the dryer.
48 in. 2
(310 cm 2)
Front
View
©
24 in. 2
(155 cm 2)
Closet
Door
3"
(76 m_

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents