in the State of Massachusetts,
the following installation instructions apply:
[] Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
the State of Massachusetts.
[] If using a ball valve, it shall be a T-handle type.
[] A flexible gas connector, when used, must not exceed 3 feet.
State of California Proposition 65 Warnings:
WARNING: This product contains one or more chemicals known to the State of California to cause cancer.
WARNING: This product contains one or more chemicals known to the State of California to cause birth defects or other
reproductive
harm.
IMPORTANT SAFETY INSTRUCTIONS
When discarding
or storing your old clothes dryer, remove the door.
SAVE THESE INSTRUCTIONS
iNSTALLATiON
Tooms and Parts
Gather the required tools and parts before starting installation.
Tools
needed:
@
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
REQUIREMENTS
Caulking
gun and compound
(for installing new exhaust
vent)
Flat-blade screwdriver
#2 Phillips screwdriver
Utility knife
Putty knife
1/4" nut driver or socket
wrench (recommended)
Tape measure
Tin snips (new vent
installations)
db
Vent clamps
8" or 10" pipe wrench
Pipe-joint compound
resistant to LP gas
8" or 10" adjustable wrench
(for gas connections)
Level
Pliers
4