Tools And Parts - Maytag YMED9000YW3 Installation Instructions Manual

INSTALLATION REQUIREMENW$
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools needed for all installations:
Tools needed for gas installations:
Flat-blade screwdriver
1/4" and 5/16" nut driver
recommended)
Tape measure
#2 Phillips screwdriver
Level
Pliers
8" or 10" pipe wrench 8" or 10" adjustable wrench
(for gas connections)
Pipe-joint compound
resistant to LP gas
Parts supplied:
Parts package is located in dryer drum. Check that all parts
are included.
NOTE: Do not use leveling legs supplied with dryer if installing
with a pedestal or a stack kit.
Leveling legs (4)
Utility knife
Caulking gun and compound
(new vent installations)
Tin snips (new vent
installations)
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Min. 8" long Torx °* T25
screwdriver
(for door reversal only)
1 ® TORX is a registered trademark of Saturn Fasteners, Inc.
4
Short inlet hose
Rubber washers
Long inlet hose
&
"Y" connector
Parts needed: (Not supplied with dryer)
[] Vent clamps
[] Vent elbows and ductwork
Additional parts may be required, depending in your installation.
Check local codes. Check existing electrical supply and venting.
Read "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Optional Equipment: (Not supplied with dryer)
Refer to your "Use and Care Guide" for information about
accessories available for your dryer.